Ready. Set. (Don’t) Crack.

“Drill through” rimless eyewear are scary to adjust. If you don’t solidly support the screw/fixture/nut assembly when adjusting the temple or bridge, the lens will crack. With this plier you can fearlessly adjust a screw and nut rimless. Our Delrin plastic jaw has a channel that holds the screw head. The opposing slotted metal jaw securely grips the retaining nut. With the mounting fixture held firmly, you can safely, but cautiously, make your adjustments.

See other models of this plier below. View all Rimless Related Products

Hold me. Hold me tight.

There are two reasons for owning this plier. The compression fixture has to be held rock solid when you need to adjust the temple or bridge. Adjusting the temple or bridge puts pressure on the drilled holes which can crack the lens. There needs to be equal pressure on both sides of the fixture for absolutely safest results. That is why our Delrin plastic jaw, for the minus side of the lens, pivots to match the base curve. 

Replacing the compression tubing is the other reason to have this plier. The Delrin plastic jaws are dual grooved to cradle the metal and plastic components, on either axis, for even, consistent pressure to drive the posts into the tubing. Opens extra wide for thick lenses.

#1050V – Black Vinyl Handle $34.95

#1050F – Green Foam Handle $34.95

See other models of this plier below. View all Rimless Related Products

Insider Info from Joshua

"I designed the first (and still the best) plier for working with compression rimless mountings. Basically, everyone else has a less functional knockoff. Our big feature is a pivoting pad. The pad that goes on the minus side of the lens pivots to match the back side base curve. If you are attempting to grasp the fixture to hold it steady while you adjust the temple the entire fixture and lens must be secured. The key is even pressure front to back. As the pads on other pliers don’t pivot, the fixture is only being held at the thickest point on the lens. This makes it much easier to inadvertently crack the lens at the drilled hole." 

There are two ways to remove the barbed post and tubing on a compression rimless mounting.

You can push it out or pull it out. This plier is for pulling. The ultrafine jaws slip under the fixture and around the posts so you can extract the assembly safely from the lens. Prevents lens breakage that results from attempting to extract the post and tubing using only your fingers.

See other models of this plier below. View all Rimless Related Products

Squeeze me. Harder.

Constructed to withstand the extra hand pressure necessary when assembling compression rimless frames. Stationary super tough Delrin plastic jaws are multi-grooved to cradle the metal and plastic fixtures on either the horizontal or vertical axis, minimizing the risk of slipping and scratching the lens. Comfortable finger-bracing handle is designed for squeezing all day long.

#2034V – Black Vinyl Handle $36.95

#2034F – Green Foam Handle $36.95

See other models of this plier below. View all Rimless Related Products

When A Push Pin Simply Won’t Do.

Compression tubing is the building block of rimless eyewear. Prepping the tubing to accept the barbed post is critical for successful assembly. The squeezing action of a tube cutter collapses the end of the tube making it difficult to get the post started. 

By inserting the metal point of this tool inside the tube, you re-establish the proper interior dimension making inserting the post easy. 3-1/2" long.

See other models of this plier below. View all Rimless Related Products